Set up a Foscam Wi-Fi camera with the app-generated QR code

Applies to: Foscam cameras supporting the Ezlink 2.0 / app-generated QR method. Models whose UID ends in ZZZ use a different documented flow; not every Foscam camera uses this method.

Prepare the camera and phone

Power the camera with its specified supply and let startup finish. New, unconfigured cameras should enter the appropriate setup state; some announce readiness. If this camera is already configured, confirm ownership and the consequences of a reset before changing it.

Connect the phone to the intended Wi-Fi. Use 2.4 GHz for a 2.4-GHz-only camera; a supported dual-band model can use its documented bands. Keep both devices near the router during initial pairing and confirm the network name and password. App-account login and camera-device credentials are separate.

Add the camera and present the second QR code

1. Open the genuine Foscam app, sign in to your account and tap + to add a camera.
2. Use the phone camera to scan the code on the camera’s label. Select the supported Wi-Fi connection setup option and confirm the camera is ready.
3. Enter the correct Wi-Fi password in the app and confirm to generate the setup QR code. The app’s exact button wording can vary.
4. Turn the phone screen towards the camera lens so the camera can read the displayed code. Foscam’s Ezlink2.0 guidance shows a distance within about 15 cm; adjust gradually, reduce glare and keep the full code visible.
5. Keep power on while configuration completes. Wait for the success indication, then open live view. If prompted on a new or reset camera, create its own strong device username and password through the app.

Manufacturer reference retained from the earlier guide: the camera reads the phone’s display. The app first scans the camera label in the opposite direction.

If scanning or pairing fails

Separate a code-reading failure from a Wi-Fi connection failure. For unreadable codes, check screen brightness, glare, lens cleanliness and distance. For a code read followed by connection failure, recheck the password, supported band and the model’s network requirements. A device already bound to another owner needs the legitimate account-transfer process; repeated factory resets do not establish ownership.

Confirm the result

The app shows live video after pairing. Place the camera in its intended location and check that live view and the required recording function still work there.

If you need help

Include camera model, firmware/app versions, supported Wi-Fi band, the last successful setup step and the exact message. Share only a sanitised screenshot that hides codes and credentials.

Updated 261108